Low Budget 5mm-LED, 500mcd, red
Easy attachment, without soldering and tinkering: the 12V LED with integrated resistor.
The resistor is set into the casing of the LED and is hardly visible to the naked eye. It has no influence on light-technical features. The LED can be used and installed as usual.
Ideal for the operation on 12-Volt batteries, car cigarette lighters or directly on a 12V-power supply unit, etc…
|Manufacturer code||12V 5mm red LED|
|Wave length (nm) |
Wave length (nm)
The dominant wavelength
indicates the perceived colour of a source which is not monochromatic but in the CIE colour space. Most actual LEDs are near the pure colour curve but not on it. When connecting and extrapolating the points W (white) and P (sample), the intersection with the colour curve yields the dominant wavelength. The dominant wavelength can further be explained via the spectrum. After assessing the spectrum of the source using the V(λ) curve, the spectral centroid is determined. The dominant wavelength provides the most accurate information about the perceived colour of a source.
|Viewing angle (°) |
Viewing angle (°)
The angle of beam
describes in what angle the light is directed forward.
|Voltage (V) |
The voltage (V)
mentioned can be impressed on the product. If your initial voltage is higher (e.g. Car-voltage or adaptor), then you will need a resistor.
|Barycentric Wave Length (nm)||630|
|Size (L x W x H)||1.0 cm x 1.0 cm x 0.0 cm|